Cluster Lash Application + Removal Guide

Breezy Lashes Cluster Lash Application and Removal Guide

Bond + Seal Clusters

Prep

Cleanse and dry lashes. Remove all oil and makeup. Curl and brush through lashes.

Apply Bond

Apply a thin layer of Bond to the base of natural lashes. Avoid skin/waterline. For a stronger hold apply also to base of cluster and wait until tacky to apply.

Place Clusters

Place clusters under natural lashes, 1-2 mm above the waterline. Work outer to inner. Design your own lash map with sizes, get creative.

Press + Secure

Clamp natural lashes and clusters together with clean tweezers. If a lash is not feeling great here's your chance to adjust.

Seal

Lightly apply Seal to the bonded area only to remove tackiness. If you saturate or apply on ends it will harden and combine lashes.

Removal - Supplied Serum

Coat the bonded area above and underneath the lash line with the supplied remover serum.
Allow the adhesive to soften, then gently slide clusters away. Never pull.
If there is resistance, apply more serum and repeat. Wash lashes once removed.

Preglued Clusters

Prep

Cleanse and dry lashes. Avoid oils or moisturiser around the lash line.

Lift from Tray

Lift each cluster from the base with clean tweezers holding at the top of cluster. Do not squeeze the preglued strip.

Place

Position under natural lashes, 1-2 mm above the waterline. Keep adhesive off skin.

Press

Press cluster and natural lashes together for 5-10 seconds. Repeat across the lash line.

Finish

Check each cluster is secure and comfortable. No Bond or Seal needed.

Preglued Removal

Starting at the outer corner, gently lift the band and slowly peel each cluster away in the direction of lash growth.
Never tug or pull. If resistant, hold a warm damp cotton pad over the lash band briefly, then try again.
Clean any remaining adhesive residue from your natural lashes and eye area before your next set.